Sony CCp-8000 Benutzerhandbuch
195
Setup for the Whole System
Ch
apt
apt
er 16
E
ngin
eering Se
tup
Setup for the Whole System
Carry out operations relating to setup in the Engineering Setup menu.
To access the Engineering Setup menu, press the top menu selection button
[ENG SETUP].
To access the Engineering Setup menu, press the top menu selection button
[ENG SETUP].
For an overview of setup, see “Setup” in Chapter 1 (Volume 1).
Setting the unit ID
When there are two switchers and connected DME units on the same network,
it is necessary to set the unit ID on each device, as follows.
it is necessary to set the unit ID on each device, as follows.
For more details of how to make the device ID settings, refer to the installation
manual for the particular device.
manual for the particular device.
Network Settings (Network Config Menu)
To display the Network Config menu
In the Engineering Setup menu, select VF1 ‘System’ and HF1 ‘Network
Config.’
The status area shows the device ID, and Control LAN and Data LAN IP
addresses for each device excluding the DCU.
Config.’
The status area shows the device ID, and Control LAN and Data LAN IP
addresses for each device excluding the DCU.
Making the network settings
Use the following procedure.
1
In the System>Network Config menu, press [Auto Config].
This automatically checks all devices (excluding the DCU) connected to
the Data LAN.
the Data LAN.
Device
ID
1st switcher
1
2nd switcher
2
Device
ID
DME for 1st switcher (channels 1 to 4)
1
DME for 2nd switcher (channels 1 to 4)
3