Sony 2 Benutzerhandbuch
Chapt
er
12
Ex
te
te
rn
al De
v
ic
e
s
94
Control of VTRs and Disk Recorders
Control of VTRs and Disk Recorders
To control a VTR or disk recorder in the DVS-9000 system, the following
settings are required.
• Button assignment: For a VTR or disk recorder connected to the DCU 9-pin
settings are required.
• Button assignment: For a VTR or disk recorder connected to the DCU 9-pin
serial port, assign a device selection button in the device control block.
• Timecode source: When using a VTR, specify a reference signal used for
determining the tape position.
For details, see “Making DCU serial port settings” (page 226) and “Making
detailed settings on the external device connected to the serial port” (page
274).
detailed settings on the external device connected to the serial port” (page
274).
Controlling the Tape/Disk Transport
Switching to VTR/disk recorder operation mode
To control a VTR or disk recorder, press the [DEV] button in the device control
block, turning it on.
This puts the device control block in VTR/disk recorder operation mode, and
the button arrangement changes as shown in the following figure. (Note that
[USER], [RUN CTRL], and [SHIFT] do not operate in VTR/disk recorder
operation mode.)
block, turning it on.
This puts the device control block in VTR/disk recorder operation mode, and
the button arrangement changes as shown in the following figure. (Note that
[USER], [RUN CTRL], and [SHIFT] do not operate in VTR/disk recorder
operation mode.)
Device control block in VTR/disk recorder operation mode (trackball type)
DEV
DEV1
DEV5
DEV9
MENU
DEV2
DEV6
DEV10
DEV3
DEV7
DEV11
REW
DEV4
STOP
DELAY
REC
DEV8
DEV12
VAR
SHTL
JOG
PLAY
FF
CUE
STB
OFF
OFF
START
TC
STOP
TC
ALL
STOP