Samsung RF260BEAEBC Benutzerhandbuch

 

setting up

INSTALLING ThE WATER 
DISPENSER LINE

A water dispenser with a filter is one of the helpful 
features on your new refrigerator. To help promote 
better health, the water filter removes unwanted 
particles from your water. However, it does not 
sterilize or destroy microorganisms. You may need 
to purchase a water purifying system to do that.
In order for the ice maker to operate properly, a 
water pressure of 20~125psi ( 138~862kPa) is 
required.
Under normal conditions, a 170 cc (5.75 oz.) cup 
can be filled in about 10 seconds.
If the refrigerator is installed in an area with low 
water pressure (below 20psi), you can install 
a booster pump to compensate for the low 
pressure.
After you have connected the water line, make 
sure the water storage tank inside the refrigerator 
is properly filled. To do this, press the water 
dispenser lever until the water runs from the water 
outlet.

Water line installation kits are available at 
extra cost from your dealer.  
We recommend using a water line 
installation kit that contains copper tubing 
and ¼” compression nut.

Connecting to the water supply line

First, shut off the main water 

supply.

Locate the nearest cold water drinking line and 

install the pipe clamp and shut off valve.

Connect the water line installation kit to the 

shut off valve.

Connecting the water supply line to 
the refrigerator.

There are several items that you need to purchase 
to complete this connection. 
You may find these items sold as a kit at your local 
hardware store.

¼” copper tubing

• 

¼” compression nut (1pc)

• 

Ferrule (2pc)

• 

¼” plastic tubing  

• 

→

 Molded end(Bulb)

¼” compression nut (1pc)

• 

Connect the household water line to the 

assembled compression fitting.
If you are using copper tubing, slip the 

 

-

compression nut ( 

B ) (not supplied) and 

ferrule (not supplied) on the copper tubing (not 
supplied) as shown.
If you are using plastic tubing ( 

 

-

B ) , insert the 

molded end (Bulb) of the plastic tubing ( 

B ) 

into the compression fitting.

Compression 

Nut (1/4”) 

(Assembled) 

Ferrule 

(Not supplied)

Plastic Tubing
(Assembled)
Compression 
Fitting
(Assembled)

Molded 
end(Bulb)

Compression  
nut (B) (1/4”)  
(Not supplied)

or

Copper tubing
(Not supplied)

Plastic tubing (B)
(Not supplied)

household water supply line

Refrigerator

DA68-02601B(EN+ES+FR)-0.0.indb   10

2012.3.29   9:28:42 AM