Inglis Home Appliances 2225407 Benutzerhandbuch

Seite von 40
14
FREEZER FEATURES
Your model may have some or all of these features. Features that 
can be purchased separately as product accessories are labeled 
with the word “Accessory.” Not all accessories will fit all models. 
If you are interested in purchasing one of the accessories, please 
call the toll-free number on the cover or in the “Assistance or 
Service” section.
Freezer Shelf
(on some models)
To remove and replace the shelf:
1.
Remove the shelf by lifting the entire shelf slightly and move it 
all the way to one side. Tilt the other side up and out of the 
shelf supports.
2.
Replace the shelf by inserting one end all the way into the 
center of the shelf supports. Then, lower the other end of the 
shelf and insert it into the shelf supports.
NOTE:
 The shelf should lower slightly and lock into place. If the 
shelf does not appear stable, make sure both ends of the shelf 
are inserted into the shelf supports.
Frozen Food Storage Guide
Storage times will vary according to the quality and type of food, 
the type of packaging or wrap used (should be airtight and 
moisture-proof), and the storage temperature. Seal the package 
or container securely to prevent taste and odor transfer 
throughout the product. Ice crystals inside a sealed package are 
normal. 
Put no more unfrozen food into the freezer than will freeze within 
24 hours (no more than 2 to 3 lbs. of food per cubic foot [907-
1,350 g per L] of freezer space). Leave enough space in the 
freezer for air to circulate around packages. The freezer door 
must close tightly. For more information on preparing food for 
freezing, check a freezer guide or reliable cookbook.
Adjustable Half-width Freezer Shelf
(on some models)
To remove and replace the shelf: 
1.
Remove the shelf by lifting the shelf up and pulling 
straight out.
2.
Replace the shelf over the supports and lower it into place.
Pull-out Freezer Floor
(on some models)
To remove and replace the freezer floor:
1.
Lift both back “fences” up and out.
2.
Remove the freezer floor by pulling it out about 1 in. (2.5 cm) 
with one hand around the air tower section (center back) and 
one hand at center front.
3.
Lift up floor at rear until hooks release from cabinet and pull 
the floor out the rest of the way.
4.
Replace the freezer floor by sliding the floor straight in until 
the hooks drop into place at rear of cabinet.
5.
Replace “fences” by aligning pins with socket in the floor, and 
pushing down until they snap into place.
DOOR FEATURES
Your model may have some or all of these features. Features that 
can be purchased separately as product accessories are labeled 
with the word “Accessory.” Not all accessories will fit all models. 
If you are interested in purchasing one of the accessories, please 
call the toll-free number on the cover or in the “Assistance or 
Service” section.
Door Rails
The door rails may be removed for easier cleaning. 
Snap-on Door Rails
To remove and replace the rails:
1.
Remove the rails by pushing in slightly on the front of the 
bracket while pulling out on the inside tab. Repeat these 
steps for the other end of the rail.
2.
Replace the rails by aligning the ends of the brackets with the 
buttons on the sides of the door liner. Firmly snap bracket 
and rail assembly onto the tabs above the shelf as shown.
Drop-in Door Rails
To remove and replace the rails:
1.
Remove the rails by pulling straight up on each end of the rail.
2.
Replace the rails by sliding the shelf rail into the slots on the 
door and pushing the rail straight down until it stops.