Smeg B71MPX5 Benutzerhandbuch

Turn the function selector knob to the 

 symbol to start the pyrolysis cycle. The orange thermostat light

comes on, followed a few minutes later by the red "door interlock" light to indicate that the appliance's
door has been locked because of the high temperature inside. As soon as the function selector knob is
turned to 

, the display shows 

 to indicate that the pyrolysis cycle will start immediately and will

last an hour and a half. The duration of the pyrolysis cycle can be increased up to a maximum of 3 hours.
To do this, after the pyrolysis cycle starts press the 

 key followed within a few seconds by the value

variation keys 

 or 

. A few seconds after the last key is pressed, the display will show the letter P

followed by the pyrolysis duration just set, and the letter A will stop flashing. After starting the pyrolysis
procedure, and modifying its duration as just described if required, the cleaning cycle end time can also
be programmed.
Press the 

 key. The letter A will flash on the display, which will also show the sum of the current time

plus the duration of the pyrolysis cycle (e.g.: current time: 12.10 - programmed duration: 2.00 - figure
shown: 14.10). At this point, press the value variation keys 

 or 

 to program the cleaning cycle end

time. A few seconds after the last key is pressed, the display will show the current time and the orange
light will go out; it will come back on at the present time.