Hoshizaki F-450MAH-C Benutzerhandbuch

13

1. All parts are factory-adjusted. Improper adjustments may adversely affect 

safety, performance, component life, and warranty coverage.

2. If the icemaker is turned off, wait for at least 3 minutes before restarting the 

icemaker to prevent damage to the compressor.

3. At startup, confirm that all internal and external connections are free of leaks.

1) Open the water supply line shut-off valve. 
2) Remove the front panel. Move the control switch on the control box to the "ICE" position, 

then move the power switch to the "ON" position. Replace the front panel in its correct 
position, then turn on the power supply to start the automatic icemaking process.

3) Once the icemaker starts to produce ice, allow it to run for another 30 minutes.
4) Turn off the power supply, then remove the front panel. 
5) Move the control switch to the "DRAIN" position, then replace the front panel in its 

correct position. Turn on the power supply and allow the water system to drain for 
5 minutes.

6) Confirm bin control operation:

a) Turn off the power supply, then remove the front and top panels.
b) Move the power switch to the "OFF" 

position.

c) Remove the strap connecting the spout 

to the chute assembly. See Fig. 5. Pull 
up the chute assembly slightly so that 
you can access the actuator located in 
the top of the chute.

d) Move the control switch to the "ICE" 

position, then move the power switch to 
the "ON" position.

e) Turn on the power supply to start 

the automatic icemaking process. 
WARNING! Keep hands, hair, and 
loose clothing clear of the cutter 
and auger on top of the evaporator 
assembly. Allow the icemaker to 
run until the compressor starts 
(approximately 60 seconds). 

f) Press and hold the actuator paddle 

located in the top of the chute. The 
icemaker should shut down within 
6 seconds.

Strap

Proximity 

Switch

Chute 

Assembly

Actuator

Spout

Strap

Bin Control Assembly