Changhong Electric LT1512E Benutzerhandbuch

PAGE  

13

 

1.  Remove the LCD TV from the box and place it on a flat surface in a well-ventilated 

location. 

2.  Connect the output terminal of RF cable to the corresponding TV RF signal input 

terminal. The LCD TV is a high-tech digital product. Do use quality RF cable to obtain 
optimal results.   

3.  Connect the output terminal of the AV devices such as YPbPr, DVD to the corresponding 

terminal of the LCD TV. 

4.  Connect one end of the VGA terminal to the corresponding signal source terminal, and 

connect the other end to the corresponding LCD TV terminal. Screw down the screws 
on both sides to secure it.     

5. Ensure that every AV signal cord is correctly connected to the corresponding interface.   
6. Connect one end of the AC power/power adapter cord to the power input jack of the LCD 

TV, then plug the other end to the corresponding jack. 

7. The panel can be tilted upwards by no more than 10

0

 to achieve better visual angle. When 

doing so, rotate the TV with two hands, one to fix the pedestal while the other to tilt the 
panel. Take great care and do this in a moderate pressure in case any accidents 
happen.(only for LT1512E LT1712E LT2012E)     

 

 

1. In Standby mode, press【

】on the remote control or front panel to enter to Power On 

mode. 

2 The indicator is red when the TV is in Standby mode. 
 

1. Press【

】on the remote control or on the front panel to switch off the TV   

2. Unplug the AC power/power adapter cord from the power outlet supply after turning off 

the power to switch the TV off completely.   

power cord from the AC outlet if so.  The last TV mode will appear when 
power resumes 

The TV will enter into Standby mode after 15 minutes when there is no signal input in TV 
source; The TV enter into power saving mode after 30 seconds when there is no signal input 
in PC source.