Bunn Ultra-1 Bedienungsanleitung

34

 

Bunn Kit #34245.0001 is required for ULTRA-1 and 

#34245.0000 is required for ULTRA-2, to perform the 

semi annual Preventive maintenance:

 

The following instructions apply to one hopper only; 

repeat each step for all hoppers.

Inventory the kit for completeness before proceeding.

 

*  **

27446.0000 

2  1 

Lamps, T-5 Wedgebase Min.

26781.0000 

2  1 

Auger Shaft Bushing (Blue)

26782.0001 

2  1 

Cooling Drum Seal

32079.0000 

2  1 

Hopper/Drum Seal

32268.0000 

2  1 

Seal, Faucet (Clear)

29563.0000 

-  - 

Lubricant (“Krytox”)

28395.0000 

1  1 

Seal Insertion Tool

FIG 1

Auger Motor Cover

Auger Motor Assy

Auger Shaft Assy

Cooling Drum

Hopper/Drum Seal

Auger Shaft Bushing

Cooling Drum Seal

P2528

Run Capacitor

WARNING - Disconnect the dispenser from the power source before the removal of any panel or the replacement 

of any component.

1.  Drain, remove and clean hopper; refer to the Operating and Service Manual for proper cleaning procedures. 

Discard the hopper/drum seal and faucet seal. 

2.  Remove the #8 locking screws securing auger motor cover to the cooling drum mount assembly; remove 

cover and set aside for reassembly.

3.  Remove the #8 locking screw on the lower right side (viewed from front) of the auger motor mounting bracket 

securing the auger motor run capacitor. Set capacitor aside with wires attached.

4.  Disconnect the auger motor terminal from the terminal on the main wiring harness.

5.  Remove the remaining #8 locking screws securing the cooling drum mounting bracket. Remove motor with 

mounting bracket.

NOTE:  When removing or installing motor and shaft assembies, be sure the motor and shaft pins are turned to 

a position that will clear the torque sensor circuit board.

40563 110207