Sony NSC-GC1 Betriebsanweisung
30
[
To remove the built-in battery
On disposal of the camera, take the following
steps to remove the built-in battery
steps to remove the built-in battery
1
Make sure your camera has been
disconnected from the power source.
disconnected from the power source.
2
Open the “Memory Stick Duo” cover
(page 8) and loosen off the two screws
using a cross-head screwdriver.
(page 8) and loosen off the two screws
using a cross-head screwdriver.
3
Insert a flat-bladed screwdriver, etc., into
the groove [A] and lift the cover up in the
direction of the arrow until the cover does
not lower back down.
the groove [A] and lift the cover up in the
direction of the arrow until the cover does
not lower back down.
4
Insert a flat-bladed screwdriver, etc., into
the “Memory Stick Duo” slot and lift the
cover up in the direction of the arrow.
the “Memory Stick Duo” slot and lift the
cover up in the direction of the arrow.
• Shift the cover while lifting it up to avoid
the tab.
5
Take the cover off and remove the battery
with the bottom surface of the camera
facing down.
with the bottom surface of the camera
facing down.
tab