Haier tel170r Benutzerhandbuch

Seite von 5
2
LAMP
7
WIRING DIAGRAM
Lamp: 220-240V,15W
Lamp holder: E14 (lamps exceeding 15W must not be used).
When replacing the lamp:
To replace the lamp:
* Unplug the appliance and remove the
water tray from under the ice box.
* Press on the front of the lamp cover
while pulling it down to release it from
the lamp holder.
* To remove the lamp, turn it anti-
clockwise.
* Replace the lamp and cover then refit
the water tray.
LAMP
REPLACEMENT
NOTICE
SETTING UP 
The fridge cannot be installed with its
rear panel directly against the wall. For
good air circulation it should have a 
gap of 100mm. Install the machine on a
 
flat and firm ground to minimize noise.
Poorly ventilated rooms 
are unsuitable. Avoid 
installing the appliance in 
direct sunshine or exposed 
to other similar sources of 
eat.
The power supply for
this appliance is 
220-240V, 50Hz 
Single phase. 
It is not 
recommended
to use extension 
cords.
Connect the appliance to a properly
earthed three pin socket. 
Never store anything dangerous
in this unit, such as 
combustibles, explosives, 
strong acid or alkali etc.