Aten kh-0116 Benutzerhandbuch

KH0116 User Manual

36

Each Computer Port is assigned a Port ID (see Port ID Numbering, p. 17). You 
can directly access any computer on the installation with a Hotkey combination 
that specifies the Port ID of the Computer Port that the computer is connected 
to. The steps involved are:

1. Invoke Hotkey Mode (see p. 35).

2. Key in the Port ID

The Port ID numbers display on the Command Line as you key them in. If 
you make a mistake, use [Backspace] to erase the wrong number.

3. Press [Enter]

After you press [Enter], the KVM focus switches to the designated 
computer and you automatically exit Hotkey Mode.

Auto Scan automatically switches among all the active Computer Ports that are 
accessible to the currently logged on User at regular intervals, so that he can 
monitor their activity automatically. (See Scan/Skip Mode of the OSD F3 SET 
function, p. 24 for information regarding accessible ports).

The amount of time Auto Scan dwells on each port is set with the Scan 
Duration setting of the OSD F3 SET function (see p. 24). You can change the 
scan interval before activating Hotkey Auto Scanning, if you wish, with the 
following Hotkey combination:

1. Invoke Hotkey Mode (see p. 35).

2. Key in [T] [n]

Where [T] is the letter T, and [n] is a number from 1-255 that represents 
the number of seconds for the dwell time.

The letter T and the numbers display on the Command Line as you key 
them in. If you make a mistake, use [Backspace] to erase the wrong 
number.

3. Press [Enter]

After you press [Enter], you automatically exit Hotkey Mode, and are 
ready to invoke Auto Scanning.

kh0116-v2.book  Page 36  Wednesday, March 22, 2006  4:53 PM