Epson RX600 Produktdatenblatt

Epson Stylus Photo RX600

2/04

Epson Stylus Photo RX600

 - 13

2. Remove the film holder from its storage place. (Remember 

to replace the film holder when you’re done using it.) 

3. Continue with one of these sections:

❏ “Loading 35 mm Film Strips in the Film Holder” below 

(for film)

❏ “Placing 35 mm Slides on the Film Holder” on page 14 

(for slides)

1. Remove the cover for the film strip holder.

2. Slide your film strip into the holder with the duller 

(emulsion) side facing up. The top of the images should be 
facing the outside edge of the film holder and the images 
should be reversed. 

3. Replace the film cover. (It should snap into place.)

4. Position the film holder so that the 35 mm film strip faces 

the center of the scanner glass. The positioning posts on the 
film holder fit in two small holes near the scanner lid, as 
shown.

5. Close the scanner lid.

Now you are ready copy, print, or scan. See the User’s Guide 
for instructions. 

Holes