Epson 800N Installationsanleitung
8
Setup Guide
Testing the Printer
If you want, you can run a test on your printer to see how it’s
working. Follow the steps in Chapter 6 of your printer User’s
Guide.
working. Follow the steps in Chapter 6 of your printer User’s
Guide.
Turn off the printer to stop test printing.
Connecting the Printer to Your
Network
Network
You can connect your Ethernet-ready printer to either an
Ethernet Thin Coaxial (10BASE2) or an Ethernet Twisted-Pair
(10BASE-T) network connection. You can only attach one
cable at a time. Follow these steps:
Ethernet Thin Coaxial (10BASE2) or an Ethernet Twisted-Pair
(10BASE-T) network connection. You can only attach one
cable at a time. Follow these steps:
1. Attach the network cable to the appropriate connecter on
the card.
2. To initialize the card, plug the printer into an electrical
outlet while pressing the status sheet button. Hold down
the button for about three seconds.
the button for about three seconds.
3. To print a status sheet, turn on the printer and press the
status sheet button again. This sheet gives you important
information including the serial number and hardware
address of the card. Keep the status sheet so you can use it
when you configure the card.
information including the serial number and hardware
address of the card. Keep the status sheet so you can use it
when you configure the card.
twisted-pair
(10BASE-T)
(10BASE-T)
thin coaxial
(10BASE2)
(10BASE2)
status
sheet
button
sheet
button
QuikSet2.fm Page 8 Wednesday, October 15, 1997 3:49 PM