Epson 800N Installationsanleitung
15
Setup Guide
Configuring for TCP/IP
You can configure the Ethernet card for TCP/IP if you are
using a UNIX TCP/IP network, a Windows 95 peer-to-peer
network, or Windows NT.
using a UNIX TCP/IP network, a Windows 95 peer-to-peer
network, or Windows NT.
Installing TCP/IP in Windows 95
Windows 95 does not come with LPR, so in addition to
installing TCP/IP, as described below, you need to install the
EPSON TCP/IP printer protocol. The EPSON Status
Monitor 2 installer program automatically prompts you when
to install EPSON TCP/IP printer protocol.
installing TCP/IP, as described below, you need to install the
EPSON TCP/IP printer protocol. The EPSON Status
Monitor 2 installer program automatically prompts you when
to install EPSON TCP/IP printer protocol.
Follow these steps to install TCP/IP:
1. Open the Control Panel.
2. Double-click the
Network
icon.
3. If TCP/IP appears in the list of installed network
components on the Configuration screen, you can skip to
“Assigning the IP Address” on page 16. If TCP/IP does not
appear in the list, click
“Assigning the IP Address” on page 16. If TCP/IP does not
appear in the list, click
Add
.
4. Click
Protocol
and then click the
Add
button.
5. Select
Microsoft
from the Manufacturers list and
TCP/IP
from the Network Protocols list. Then click
OK
.
6. Click
OK
again and follow any on-screen instructions to
enable TCP/IP.
QuikSet2.fm Page 15 Wednesday, October 15, 1997 3:49 PM