Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Ratgeber Für Administratoren

command to enable traffic shaping by specifying the maximum transmission bandwidth limit 
for all interfaces (Global Config) or for a single interface (Interface Config). 

The <bw> value is a percentage that ranges from 0 to 100 in increments of 5. The default 
bandwidth value is 0, meaning no upper limit is enforced, which allows the interface to 
transmit up to its maximum line rate. 

The bw value is independent of any per-queue maximum bandwidth values in effect for the 
interface and should be considered as a second-level transmission rate control mechanism 
that regulates the output of the entire interface regardless of which queues originate the 
outbound traffic.

CLI: Configure traffic-shape

Web Interface: Configure Traffic Shaping

Set the shaping bandwidth percentage to 70 percent.

a. Select QoS > CoS > Advanced > CoS Interface Configuration. A screen similar to 

the following displays.

b.  Under CoS Interface Configuration, scroll down and select the interface 1/0/3 check 

box. Now 1/0/3 appears in the Interface field at the top.

c.  In the Interface Shaping Rate (0 to 100) field, enter 70.

d.  Click Apply to save the settings.

(Netgear Switch) (Config)#traffic-shape?

<bw>                     Enter the shaping bandwidth percentage from 0 to 100

                         in increments of 5.

(Netgear Switch) (Config)#traffic-shape 70?

<cr>                     Press Enter to execute the command.

(Netgear Switch) (Config)#traffic-shape 70

(Netgear Switch) (Config)#