Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Ratgeber Für Administratoren
348
|
Chapter 19. Switch Stacks
ProSafe Managed Switch
CLI: Stack Switches Using 10G Fiber
1.
On Switch A, show the port information.
In this case, port 1/0/52 has been configured as stack, so no action is needed.
2.
On Switch B, show the stack port information.
3.
Since 2/0/28 is in Ethernet mode, it must be changed to stack mode.
4.
Reboot Switch B.
(Netgear Switch) #show stack-port
Configured Running Link
Stack Stack Link Speed
Unit Intf SlotId Type XFP Adapter Mode Mode Status (Gb/s)
---- ------ ------- ----- ----------- --------- -------- -------- --------
1 0/51 None Ethernet Ethernet Link Down 12
1 0/52 AX741 Stack Stack Link Down 0
(Netgear Switch) #show stack-port
Configured Running Link
Stack Stack Link Speed
Unit Intf SlotId Type XFP Adapter Mode Mode Status (Gb/s)
---- ------ ------- ----- ----------- --------- -------- -------- --------
2 0/27 None Stack Stack Link Down 0
2 0/28 AX741 Ethernet Ethernet Link Down 12
(Netgear Switch) (Config)#stack
(Netgear Switch) (Config-stack)#stack-port 2/0/28 stack
(Netgear Switch) (Config-stack)#exit
(Netgear Switch) (Config)
(Netgear Switch) #reload
Management switch has unsaved changes.
Would you like to save them now? (y/n) n
Configuration Not Saved!
Are you sure you want to reload the stack? (y/n) y
Reloading all switches.