Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Ratgeber Für Administratoren
386
|
Chapter 23. DHCPv6 Server
ProSafe Managed Switch
a. Select System > Services > DHCPv6 Server > DHCPv6 Binding Information. A
screen similar to the following displays.
Configure Stateless DHCPv6 Server
This example uses the DHCPv6 server to configure the information about DNS server to
those clients which get IPv6 in autoconfig mode or manual mode. The configured DHCP pool
doesn’t contain a prefix pool but contains DNS server to be passed to clients. The IPv6
interface must have the ‘ipv6 nd other-config-flag’ command enabled.
those clients which get IPv6 in autoconfig mode or manual mode. The configured DHCP pool
doesn’t contain a prefix pool but contains DNS server to be passed to clients. The IPv6
interface must have the ‘ipv6 nd other-config-flag’ command enabled.
CLI: Configure Stateless DNS Server
This example shows how to configure a DNS server to clients with stateless IPv6 address
using DHCPv6 server.
using DHCPv6 server.
1.
Enable ipv6 routing.
2.
Create an IPv6 pool with DNS server and enable dhcpv6 service.
3.
Enable IPv6 DHCP server on interface 2/0/21.
(Netgear Switch) (Config)#ipv6 unicast-routing
(Netgear Switch) (Config)#ipv6 dhcp pool ipv6_server
(Netgear Switch) (Config-dhcp6s-pool)#dns-server 2011:9:18::1
(Netgear Switch) (Config-dhcp6s-pool)#exit
(Netgear Switch) (Config)#service dhcpv6