Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Ratgeber Für Administratoren

CLI: Create a Tunnel

Configure Switch GSM7328S_1

This example is using 6in4 mode. If you want to use 6to4 mode, configure each unit as below 
and be sure the IPv6 prefix s constructed in the format of 2002:V4ADDR::/48.(V4ADDR is the 
IPv4 address of the tunnel source port). In this case, IPv4 and the address is 192.168.1.1 
and IPv6 prefix is 2002:c0a8:0101..

(Netgear Switch) #config

(Netgear Switch) (Config)#ip routing

(Netgear Switch) (Config)#ipv6 forwarding 

(Netgear Switch) (Config)#ipv6 unicast-routing 

(Netgear Switch) (Config)#interface 1/0/1

(Netgear Switch) (Interface 1/0/1)#routing

(Netgear Switch) (Interface 1/0/1)#ip address 192.168.1.1 255.255.255.0

(Netgear Switch) (Interface 1/0/1)#exit

(Netgear Switch) (Config)#interface tunnel 0

(Netgear Switch) (Interface tunnel 0)#ipv6 enable 

(Netgear Switch) (Interface tunnel 0)#ipv6 address 2000::1/64

(Netgear Switch) (Interface tunnel 0)#tunnel mode ipv6ip 

(Netgear Switch) (Interface tunnel 0)#tunnel source 192.168.1.1

(Netgear Switch) (Interface tunnel 0)#tunnel destination 192.1.168.1.2

(Netgear Switch) (Interface tunnel 0)#exit

(Netgear Switch) (Config)#exit

(Netgear Switch) (Interface tunnel 0) # ipv6 enable

(Netgear Switch) (Interface tunnel 0) # tunnel mode ipv6ip 6to4

(Netgear Switch) (Interface tunnel 0) # tunnel source 192.168.1.1

(Netgear Switch) (Interface tunnel 0) # ipv6 address 2002:c0a8:0101::1/128

(Netgear Switch) (Interface tunnel 0) # exit

(Netgear Switch) (Config) # ipv6 route 2002::/16 interface tunnel 0