Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Softwarehandbuch

For

 

information about CLI initial configuration, see the ProSafe 

Managed Switch Command Line Interface (CLI) User Manual. 

The Setup Wizard sets up the following configuration on the switch:

Establishes the initial privileged user account with a valid password. Sets up the IP 
address for the management interface.

Allows you to specify the management IP address.

Configures the default gateway IP address.

Set up system Name and Location information for identifying the switch in the network.

Software Installation

This section contains procedures to help you become acquainted quickly with the switch 
software. Before installing switch software, verify that the switch operates with the most 
recent firmware.

Quick-Start the Networking Device

Configure the switch for in-band or out-of-band connectivity. In-band connectivity allows 

access to the software locally or from a remote workstation. Configure the device with IP 

information (IP address, subnet mask, and default gateway).

Turn on the power.

Allow the device to load the software until the login prompt displays. The initial state of the 

device is called the default mode.

When the prompt asks for operator login, perform the following steps:

Type admin

at the login prompt. Since a number of the Quick Start commands 

require administrator account rights, login to an administrator account.

Do not enter a password because the default mode does not use a password.

Check that the CLI User EXEC prompt is displayed.

Enter 

 to select Privileged EXEC mode from User EXEC. 

Enter 

 to switch to the Global Config mode from Privileged EXEC. 

Enter 

 to return to the previous mode.

Enter 

to show a list of commands that are available in the current mode. 

System Information and System Setup

This section describes the commands you use to view system information and to set up the 
network device. The following table contains the Quick Start commands that allow you to view 
or configure the following information: