Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Softwarehandbuch
16
Managed Switches
Save the Configuration
After the name and location values are entered, ezconfig asks if you would like to have the
changes be saved in flash (permanent storage). Enter Y to save the configuration.
changes be saved in flash (permanent storage). Enter Y to save the configuration.
There are changes detected, do you wish to save the changes
permanently (Y/N)?
permanently (Y/N)?
y
The configuration changes have been saved successfully.
Please enter 'show running-config' to see the final configuration.
Thanks for using EzConfig!
If the switch loses its power during the session, the setup information is lost if ezconfig does
not have the chance to save the changes before power-down.
not have the chance to save the changes before power-down.
Use the Web Interface
This section is a brief introduction to the web interface; for example, it explains how to access
the Web-based management screens to configure and manage the system.
the Web-based management screens to configure and manage the system.
Tip:
Use the web interface for configuration instead of the CLI. Web
configuration is quicker and easier than entering the multiple required
CLI commands. There are equivalent functions in the web interface and
the terminal interface—that is, both applications usually employ the same
commands to accomplish a task. For example, when you log in, there is
a main menu with the same functions available.
configuration is quicker and easier than entering the multiple required
CLI commands. There are equivalent functions in the web interface and
the terminal interface—that is, both applications usually employ the same
commands to accomplish a task. For example, when you log in, there is
a main menu with the same functions available.
You can manage your switch through a web browser and Internet connection. This process is
referred to as Web-based management. For you to use Web-based management, the system
must be set up for in-band connectivity.
referred to as Web-based management. For you to use Web-based management, the system
must be set up for in-band connectivity.
To access the switch, the web browser must support:
•
HTML version 4.0, or later
•
HTTP version 1.1, or later
•
JavaScript
version 1.6, or later
There are several differences between the web and terminal interfaces. For example, on the
web interface the entire forwarding database can be displayed, while the terminal interface
displays only ten entries starting at specified addresses. To terminate the web login session,
close the web browser.
web interface the entire forwarding database can be displayed, while the terminal interface
displays only ten entries starting at specified addresses. To terminate the web login session,
close the web browser.