Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Softwarehandbuch

1.   

Getting Started

This manual includes software configuration tasks that are most commonly used when new 
switches are installed. To configure the switch software, connect a terminal to the switch. 

Some products have Release Notes> Release Notes detail the 
platform-specific functionality of the switching, routing, SNMP, 
config, management, and other features. It is a good idea to read 
the Release Notes before setting up the switch.

A number of other publications are available for your switch, including the following:

The NETGEAR Quick Installation Guide for your switch

The Hardware Installation Guide for your switch

ProSafe Managed Switch Command Line Interface (CLI) User Manual. Refer to this 
document for information about the command structure. This manual provides 
information about the CLI commands used to configure the switch and the stack. It 
provides CLI descriptions, syntax, and default values.

These documents can be found at 

.

In-Band and Out-of-Band Connectivity

Ask the system administrator to determine whether you configure the switch for in-band or 
out-of-band connectivity.

Configure the Switch for In-Band Connectivity

In-band connectivity allows you to access the switch from a remote workstation using the 
Ethernet network. To use in-band connectivity, configure the switch with IP information (IP 
address, subnet mask, and default gateway).