Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Softwarehandbuch
IPv6 Multicast Commands
1153
M5300, M6100, and M7100 Series ProSAFE Managed Switches
IPv6 Multicast Forwarder
ipv6 mroute
This command configures an IPv6 Multicast Static Route for a source.
no ipv6 mroute
This command removes the configured IPv6 Multicast Static Route.
Note:
There is no specific IP multicast enable for IPv6. Enabling of multicast
at global config is common for both IPv4 and IPv6.
at global config is common for both IPv4 and IPv6.
show ipv6 mroute
Use this command to show the mroute entries that are specific to IPv6. (This command is the
IPv6 equivalent of the IPv4 show ip mcast mroute command.)
IPv6 equivalent of the IPv4 show ip mcast mroute command.)
Default
No MRoute is configured on the system.
Format
ipv6 mroute src-ip-addr src-mask rpf-addr [interface] preference
Mode
Global Config
Parameter
Description
src-ip-addr
The IP address of the multicast source network.
src-mask
The IP mask of the multicast data source.
rpf-ip-addr
The IP address of the RPF next-hop router toward the source.
interface
[Optional] Specify the interface if the RPF Address is a link-local address.
preference
The administrative distance for this Static MRoute, that is, the preference value. The range is 1 to
255.
255.
Format
no ip mroute src-ip-addr
Mode
Global Config
Format
show ipv6 mroute [[detail] | [summary] | [group {group-address} [detail |
summary]] | [source {source-address} [detail | summary]]]
Modes
Privileged EXEC
User EXEC