Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Softwarehandbuch
Power over Ethernet Commands
1185
M5300, M6100, and M7100 Series ProSAFE Managed Switches
PoE Commands
poe
Use this command to enable the Power over Ethernet (PoE) functionality on a global basis or
per interface.
per interface.
no poe
Use this command to disable the Power over Ethernet (PoE) functionality on a global basis or
per interface.
per interface.
poe detection
Use this command to configure the detection type on a global basis or per interface. It is used
to configure which types of PDs will be detected and powered by the switch. There are three
options:
to configure which types of PDs will be detected and powered by the switch. There are three
options:
•
ieee
—Detect resistive-type devices (IEEE standard)
•
pre-ieee
—Legacy capacitive detection only (nonstandard)
•
auto
—Perform resistive detection first (IEEE standard) and capacitive detection
(pre-IEEE standard)
no poe detection
Use this command to set the detection mode to the default on a global basis or per interface.
Default
enabled
Format
poe
Mode
Global Config
Interface Config
Format
no poe
Mode
Global Config
Interface Config
Default
auto
Format
poe detection {ieee | pre-ieee | auto}
Mode
Global Config
Interface Config
Format
no poe detection
Mode
Global Config
Interface Config