Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Softwarehandbuch

You can configure which traps the switch must generate by enabling 
or disabling the trap condition. If a trap condition is enabled and the 
condition is detected, the SNMP agent on the switch sends the trap to 
all enabled trap receivers. Cold and warm start traps are always 
generated and cannot be disabled.

This section describes the commands you use to configure the switch to use a Remote 

Authentication Dial-In User Service (RADIUS) server on your network for authentication and 

accounting.

Format

show trapflags

Mode

Privileged EXEC

Authentication Flag Can be enabled or disabled. The factory default is enabled. Indicates whether authentication failure 

traps will be sent. 

Link Up/Down Flag

Can be enabled or disabled. The factory default is enabled. Indicates whether link status traps will 
be sent.

Multiple Users Flag Can be enabled or disabled. The factory default is enabled. Indicates whether a trap will be sent 

when the same user ID is logged into the switch more than once at the same time (either through 
Telnet or the serial port). 

Spanning Tree 
Flag

Can be enabled or disabled. The factory default is enabled. Indicates whether spanning tree traps 
are sent. 

ACL Traps

May be enabled or disabled. The factory default is disabled. Indicates whether ACL traps are sent.

BGP4 Traps

Can be enabled or disabled. The factory default is disabled. Indicates whether BGP4 traps are sent. 
(This field appears only on systems with the BGPv4 software package installed.)

DVMRP Traps

Can be enabled or disabled. The factory default is disabled. Indicates whether DVMRP traps are 
sent. 

OSPFv2 Traps

Can be enabled or disabled. The factory default is disabled. Indicates whether OSPF traps are sent. 
If any of the OSPF trap flags are not enabled, then the command displays 

disabled. Otherwise, the 

command shows all the enabled OSPF traps’ information.

OSPFv3 Traps

Can be enabled or disabled. The factory default is disabled. Indicates whether OSPF traps are sent. 
If any of the OSPFv3 trap flags are not enabled, then the command displays 

disabled. Otherwise, 

the command shows all the enabled OSPFv3 traps’ information.

PIM Traps

Can be enabled or disabled. The factory default is disabled. Indicates whether PIM traps are sent.