Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Softwarehandbuch

The CLI groups commands into modes according to the command function. Each of the 
command modes supports specific NETGEAR Managed Switch  software commands. The 
commands in one mode are not available until you switch to that particular mode, with the 
exception of the User EXEC mode commands. You can execute the User EXEC mode 
commands in the Privileged EXEC mode.

The command prompt changes in each command mode to help you identify the current 
mode. The following table describes the command modes and the prompts visible in that 
mode.

The command modes available on your switch depend on the software 
modules that are installed. For example, a switch that does not support 
BGPv4 does not have the BGPv4 Router Command Mode.

User EXEC

Switch>

Contains a limited set of commands to view 
basic system information.

Privileged EXEC

Switch#

Allows you to issue any EXEC command, 

enter the VLAN mode, or enter the Global 
Configuration mode.

Global Config

Switch (Config)#

Groups general setup commands and 
permits you to make modifications to the 
running configuration.

VLAN Config

Switch (Vlan)#

Groups all the VLAN commands.

Interface Config 

Switch (Interface 

unit/slot/port)#

Manages the operation of an interface and 
provides access to the router interface 
configuration commands.

Use this mode to set up a physical port for a 
specific logical connection operation.

Switch (Interface Loopback id)#

Switch (Interface Tunnel id)#

Switch (Interface unit/slot/port 

(startrange)-unit/slot/port 

(endrange)#

Use this mode to manage the operation of a 
range of interfaces. For example the prompt 
may display as follows:

Switch (Interface 1/0/1-1/0/4) #

Switch (Interface lag 

lag-intf-num)#

Enters LAG Interface configuration mode for 
the specified LAG.

Switch (Interface vlan vlan-id)#

Enters VLAN routing interface configuration 
mode for the specified VLAN ID.