Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Softwarehandbuch
Utility Commands
223
M5300, M6100, and M7100 Series ProSAFE Managed Switches
password (Mail Server Config)
This command configures the password the switch uses to authenticate with the SMTP
server.
server.
show mail-server config
This command displays information about the email alert configuration.
System Utility and Clear Commands
This section describes the commands you use to help troubleshoot connectivity issues and to
restore various configurations to their factory defaults.
restore various configurations to their factory defaults.
traceroute
Use the traceroute command to discover the routes that IPv4 or IPv6 packets actually
take when traveling to their destination through the network on a hop-by-hop basis.
Traceroute continues to provide a synchronous response when initiated from the CLI.
take when traveling to their destination through the network on a hop-by-hop basis.
Traceroute continues to provide a synchronous response when initiated from the CLI.
The user may specify the source IP address of the traceroute probes. Recall that traceroute
works by sending packets that are expected not to reach their final destination, but instead
trigger ICMP error messages back to the source address from each hop along the forward
path to the destination. By specifying the source address, the user can determine where
along the forward path there is no route back to the source address. Note that this is only
useful if the route from source to destination and destination to source is symmetric.) It would
be common, for example, to send a traceroute from an edge router to a target higher in the
works by sending packets that are expected not to reach their final destination, but instead
trigger ICMP error messages back to the source address from each hop along the forward
path to the destination. By specifying the source address, the user can determine where
along the forward path there is no route back to the source address. Note that this is only
useful if the route from source to destination and destination to source is symmetric.) It would
be common, for example, to send a traceroute from an edge router to a target higher in the
Default
admin
Format
password password
Mode
Mail Server Config
Format
show mail-server {ip-address | hostname | all} config
Mode
Privileged EXEC
Term
Definition
No of mail servers configured
The number of SMTP servers configured on the switch.
Email Alert Mail Server Address
The IPv4/IPv6 address or DNS hostname of the configured SMTP server.
Email Alert Mail Server Port
The TCP port the switch uses to send email to the SMTP server
Email Alert Security Protocol
The security protocol (TLS or none) the switch uses to authenticate with the SMTP
server.
server.
Email Alert Username
The username the switch uses to authenticate with the SMTP server.
Email Alert Password
The password the switch uses to authenticate with the SMTP server.