Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Softwarehandbuch
Switching Commands
364
M5300, M6100, and M7100 Series ProSAFE Managed Switches
Command example:
(NETGEAR switch) #show port description 0/1
Interface...........0/1
ifIndex.............1
Description.........
MAC address.........00:10:18:82:0C:10
Bit Offset Val......1
Spanning Tree Protocol Commands
This section describes the commands you use to configure Spanning Tree Protocol (STP).
STP helps prevent network loops, duplicate messages, and network instability.
STP helps prevent network loops, duplicate messages, and network instability.
Note:
STP is enabled on the switch and on all ports and LAGs by default.
If STP is disabled, the system does not forward BPDU messages.
If STP is disabled, the system does not forward BPDU messages.
spanning-tree
This command sets the spanning-tree operational mode to enabled.
no spanning-tree
This command sets the spanning-tree operational mode to disabled. While disabled, the
spanning-tree configuration is retained and can be changed, but is not activated.
spanning-tree configuration is retained and can be changed, but is not activated.
MAC address
The MAC address of the port. The format is 6 two-digit hexadecimal numbers that are separated by
colons, for example 01:23:45:67:89:AB.
colons, for example 01:23:45:67:89:AB.
Bit Offset Val
The bit offset value.
Default
enabled
Format
spanning-tree
Mode
Global Config
Format
no spanning-tree
Mode
Global Config
Term
Definition