Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Softwarehandbuch

This section describes the commands you use to configure provisioning (IEEE 802.1p,) 
which allows you to prioritize ports.

This command configures the port priority assigned for untagged packets for all ports 
presently plugged into the device. The range for the priority is 0-7. Any subsequent per port 
configuration will override this configuration setting.

This command configures the default 802.1p port priority assigned for untagged packets for a 
specific interface. The range for the priority is 0–7.

Asymmetric Flow Control is not supported on Fast Ethernet platforms.

If Asymmetric Flow Control is not supported on the platform, then only 
symmetric, or no flow control, modes are configurable.

When in asymmetric flow control mode, the switch responds to PAUSE frames received from 
a peer by stopping packet transmission, but the switch does not initiate MAC control PAUSE 
frames.

When you configure the switch in asymmetric flow control (or no flow control mode), the 
device is placed in egress drop mode. Egress drop mode maximizes the throughput of the 
system at the expense of packet loss in a heavily congested system, and this mode avoids 
head-of-line blocking.

Format

vlan port priority all priority

Mode

Global Config

Default

0

Format

vlan priority priority

Mode

Interface Config