Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Softwarehandbuch
Switching Commands
607
M5300, M6100, and M7100 Series ProSAFE Managed Switches
MAC Database Commands
This section describes the commands you use to configure and view information about the
MAC databases.
MAC databases.
bridge aging-time
This command configures the forwarding database address aging time-out in seconds. The
seconds
seconds
parameter must be within the range of 10 to 1,000,000 seconds. In an SVL
system, the [fdbid/all] parameter is not used and will be ignored if entered. In an SVL system,
the [fdbid/all] parameter is not used and will be ignored if entered.
the [fdbid/all] parameter is not used and will be ignored if entered.
no bridge aging-time
This command sets the forwarding database address aging timeout to the default value. In
an SVL system, the [fdbid/all] parameter is not used and will be ignored if entered.
an SVL system, the [fdbid/all] parameter is not used and will be ignored if entered.
show forwardingdb agetime
This command displays the timeout for address aging.
TCP Fragment Mode
The administrative mode of TCP Fragment DoS prevention. Enabling this
causes the switch to drop packets that have a TCP payload in which the IP
payload length minus the IP header size is less than the minimum allowed
TCP header size.
causes the switch to drop packets that have a TCP payload in which the IP
payload length minus the IP header size is less than the minimum allowed
TCP header size.
TCP Offset Mode
The administrative mode of TCP Offset DoS prevention. Enabling this causes
the switch to drop packets that have a TCP header Offset equal to 1.
the switch to drop packets that have a TCP header Offset equal to 1.
Default
300
Format
bridge aging-time seconds
Mode
Global Config
Format
no bridge aging-time
Mode
Global Config
Default
all
Format
show forwardingdb agetime
Mode
Privileged EXEC
Term
Definition