Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Softwarehandbuch
Routing Commands
722
M5300, M6100, and M7100 Series ProSAFE Managed Switches
Virtual Router Redundancy Protocol Commands
This section describes the commands you use to view and configure Virtual Router
Redundancy Protocol (VRRP) and to view VRRP status information. VRRP helps provide
failover and load balancing when you configure two devices as a VRRP pair.
Redundancy Protocol (VRRP) and to view VRRP status information. VRRP helps provide
failover and load balancing when you configure two devices as a VRRP pair.
ip vrrp (Global Config)
Use this command in Global Config mode to enable the administrative mode of VRRP on the
router.
router.
no ip vrrp
Use this command in Global Config mode to disable the default administrative mode of
VRRP on the router.
VRRP on the router.
ip vrrp (Interface Config)
Use this command in Interface Config mode to create a virtual router associated with the
interface or range of interfaces. The parameter vrid is the virtual router ID, which has an
integer value range from 1 to 255.
interface or range of interfaces. The parameter vrid is the virtual router ID, which has an
integer value range from 1 to 255.
Term
Definition
MAC Address used
by Routing VLANs
by Routing VLANs
The MAC Address associated with the internal bridge-router interface (IBRI). The same MAC
Address is used by all VLAN routing interfaces. It will be displayed above the per-VLAN information.
VLAN ID
The identifier of the VLAN.
Logical Interface
The logical unit/slot/port associated with the VLAN routing interface.
IP Address
The IP address associated with this VLAN.
Subnet Mask
The subnet mask that is associated with this VLAN.
Default
none
Format
ip vrrp
Mode
Global Config
Format
no ip vrrp
Mode
Global Config
Format
ip vrrp vrid
Mode
Interface Config