Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Softwarehandbuch

This command displays information relevant to the OSPF router. 

Some of the information below displays only if you enable OSPF and 
configure certain features.

Format

clear ip ospf stub-router

Mode

Privileged EXEC

Format

show ip ospf

Mode

Privileged EXEC

Router ID

A 32-bit integer in dotted decimal format identifying the router, about which information is displayed. 

This is a configured value.

OSPF Admin Mode Shows whether the administrative mode of OSPF in the router is enabled or disabled. This is a 

configured value.

RFC 1583 
Compatibility

Indicates whether 1583 compatibility is enabled or disabled. This is a configured value.

External LSDB 
Limit

The maximum number of nondefault AS-external-LSA (link state advertisement) entries that can be 
stored in the link-state database.

Exit Overflow 
Interval

The number of seconds that, after entering overflow state, a router will attempt to leave overflow 
state.

Spf Delay Time

The number of seconds between two subsequent changes of LSAs, during which time the routing 
table calculation is delayed.

Spf Hold Time

The number of seconds between two consecutive spf calculations.

Flood Pacing 
Interval

The average time, in milliseconds, between LS Update packet transmissions on an interface. This is 
the value configured with the command 

LSA Refresh Group 
Pacing Time

The size in seconds of the LSA refresh group window. This is the value configured with the 
command 

Opaque Capability

Shows whether the router is capable of sending Opaque LSAs. This is a configured value.

Autocost Ref BW

Shows the value of auto-cost reference bandwidth configured on the router.

Default Passive 
Setting

Shows whether the interfaces are passive by default.