Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Softwarehandbuch

The following example displays output for the service port:

(admin) #show serviceport

 

Interface Status............................... Up

IP Address..................................... 10.230.3.51

Subnet Mask.................................... 255.255.255.0

Default Gateway................................ 10.230.3.1

IPv6 Administrative Mode....................... Enabled

IPv6 Prefix is ................................ fe80::210:18ff:fe82:640/64

IPv6 Prefix is ................................ 2005::21/128

IPv6 Default Router is ........................ fe80::204:76ff:fe73:423a

Configured IPv4 Protocol ...................... DHCP

Configured IPv6 Protocol ...................... DHCP

DHCPv6 Client DUID ............................ 00:03:00:06:00:10:18:82:06:4C

IPv6 Autoconfig Mode........................... Disabled

Burned In MAC Address.......................... 00:10:18:82:06:4D

DHCP Client Identifier......................... 0NETGEAR-0010.1882.160C

This section describes the commands you use to configure the console port. You can use a 
serial cable to connect a management host directly to the console port of the switch.

This command gives you access to the Global Config mode. From the Global Config mode, 
you can configure a variety of system settings, including user accounts. From the Global 
Config mode, you can enter other command modes, including Line Config mode.

DHCPv6 Client DUID

The DHCPv6 client’s unique client identifier. This row is displayed only when the configured 
IPv6 protocol is dhcp.

IPv6 Autoconfig Mode

Whether IPv6 Stateless address autoconfiguration is enabled or disabled.

Burned in MAC Address

The burned in MAC address used for in-band connectivity.

DHCP Client Identifier

The client identifier is displayed in the output of the command only if DHCP is enabled with 
the client-id option on the service port. 

Format

configure

Mode

Privileged EXEC