Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Softwarehandbuch

This section describes the commands you use to configure Secure Shell (SSH) access to the 
switch. Use SSH to access the switch from a remote management host.

The system allows a maximum of 5 SSH sessions.

Use this command to enable SSH access to the system. (This command is the short form of 
the ip ssh server enable command.)

This command is used to set or remove protocol levels (or versions) for SSH. Either SSH1 
(1), SSH2 (2), or both SSH 1 and SSH 2 (1 and 2) can be set.

This command enables the IP secure shell server. No new SSH connections are allowed, but 
the existing SSH connections continue to work until timed-out or logged-out.

This command disables the IP secure shell server.

Default

disabled

Format

ip ssh

Mode

Privileged EXEC

Default

2

Format

ip ssh protocol [1] [2]

Mode

Privileged EXEC

Default

enabled

Format

ip ssh server enable

Mode

Privileged EXEC

Format

no ip ssh server enable

Mode

Privileged EXEC