Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Softwarehandbuch
IPv6 Commands
932
M5300, M6100, and M7100 Series ProSAFE Managed Switches
no interface loopback
This command removes the loopback interface and associated configuration parameters for
the specified loopback interface.
the specified loopback interface.
show interface loopback
This command displays information about configured loopback interfaces.
If you do not specify a loopback ID, the following information appears for each loopback
interface on the system.
interface on the system.
If you specify a loopback ID, the following information appears.
IPv6 Routing Commands
This section describes the IPv6 commands you use to configure IPv6 on the system and on
the interfaces. This section also describes IPv6 management commands and show
commands.
the interfaces. This section also describes IPv6 management commands and show
commands.
Note:
IPv6 routing commands are supported on the M5300 and M6100
series switches only.
series switches only.
Format
no interface loopback loopback-id
Mode
Global Config
Format
show interface loopback [loopback-id]
Mode
Privileged EXEC
Term
Definition
Loopback ID
The loopback ID associated with the rest of the information in the row.
Interface
The interface name.
IP Address
The IPv4 address of the interface.
Term
Definition
Interface Link
Status
Status
Shows whether the link is up or down.
IP Address
The IPv4 address of the interface.
MTU size
The maximum transmission size for packets on this interface, in bytes.