Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Softwarehandbuch

Use this command to revert to the default reference bandwidth. 

To disable the individual flag, enter the no trapflags group name followed by a 
particular flag.

To disable all the flags in that group, enter no trapflags group name followed by 
all

.

To disable all the flags, enter the command as no trapflags all.

This command sets the OSPF area to which the specified router interface or range of 
interfaces belongs. It also enables OSPF on the specified router interface or range of 
interfaces. The area-id is a 32-bit integer, formatted as a 4-digit dotted-decimal number or 
a decimal value in the range of 0-4294967295. The area-id uniquely identifies the area to 
which the interface connects. Assigning an area ID for an area that does not yet exist, causes 
the area to be created with default values.

This command configures the cost on an OSPF interface or range of interfaces. The cost 
parameter has is in the range of 1 to 65535.

Default

disabled

Format

trapflags {all | errors {all | authentication-failure | bad-packet | 

config-error | virt-authentication-failure | virt-bad-packet | 

virt-config-error} | lsa {all | lsa-maxage | lsa-originate} | overflow {all | 

lsdb-overflow | lsdb-approaching-overflow} | retransmit {all | packets | 

virt-packets} | state-change {all | if-state-change | neighbor-state-change | 

virtif-state-change | virtneighbor-state-change}}

Mode

Router OSPFv3 Config

Format

no trapflags {all | errors {all | authentication-failure | bad-packet | 

config-error | virt-authentication-failure | virt-bad-packet | 

virt-config-error} | lsa {all | lsa-maxage | lsa-originate} | overflow {all | 

lsdb-overflow | lsdb-approaching-overflow} | retransmit {all | packets | 

virt-packets} | state-change {all | if-state-change | neighbor-state-change | 

virtif-state-change | virtneighbor-state-change}}

Mode

Router OSPFv3 Config

Format

ipv6 ospf area area-id

Mode

Interface Config