Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Ratgeber Für Administratoren
RIP
125
Managed Switches
Enable RIP on the Switch
Note:
Unless you have previously disabled RIP, you can skip this step since
RIP is enabled by default.
RIP is enabled by default.
CLI: Enable RIP on the Switch
This sequence enables RIP for the switch. The route preference defaults to 15.
(Netgear Switch) #config
(Netgear Switch) (Config)#router rip
(Netgear Switch) (Config router)#enable
(Netgear Switch) (Config router)#exit
(Netgear Switch) (Config)#exit
Web Interface: Enable RIP on the Switch
1.
Select Routing > RIP > Basic > RIP Configuration.
A screen similar to the following displays.
2.
For RIP Admin Mode, select Enable radio button.
3.
Click Apply to save the setting.