Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Ratgeber Für Administratoren
OSPF
146
Managed Switches
b. Under Interface Configuration, scroll down and select the interface 1/0/4 check box.
Now 1/0/4 appears in the Interface field at the top.
•
In the OSPF Area ID field, enter 0.0.0.2.
•
In the OSPF Admin Mode field, select the Enable.
•
In the Priority field, enter 255.
•
In the Metric Cost field, enter 64.
c. Click Apply to save the settings.
Stub Areas
The example is shown as CLI commands and as a web interface procedure.
Port 2/0/11
Port 2/0/19
Port 1/0/15
Layer 3
switch
switch
Area 0
Area 1
Layer 3
switch
switch
Figure 15. Area 1 is a stub area
CLI: Configure Area 1 as a Stub Area on A1
1.
Enable routing on the switch.
(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing
2.
Set the router ID to 1.1.1.1.
(Netgear Switch) (Config)#router ospf
(Netgear Switch) (Config-router)#router-id 1.1.1.1
3.
Configure area 0.0.0.1 as a stub area
(Netgear Switch) (Config-router)#area 0.0.0.1 stub
.