Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Ratgeber Für Administratoren
DiffServ
308
Managed Switches
2.
Display the Auto VoIP information.
(Netgear Switch) #show auto-voip protocol-based interface 2/0/1
VoIP VLAN Id................................... 2
Prioritization Type............................ traffic-class
Class Value.................................... 6
Interface Auto VoIP Mode Operational Status
--------- -------------- -----------------
2/0/1 Enabled Up
Web Interface: Configure Protocol-Based Auto VoIP
1.
Enable protocol-based Auto VoIP on a specific port of the switch:
a. Select Switching > Auto-VoIP > Protocol-based > Port Settings.
A screen similar to the following displays.
b. Scroll down and select the interface 2/0/1 check box.
The Interface field in the table heading displays 2/0/1.
c. From the Auto VoIP Mode mode, select Enable.
d. Click Apply.
Example 2: Change the Queue of Protocol-Based Auto VoIP
This example is provided as CLI commands and as a web interface procedure.
CLI: Change the Queue of Protocol-Based Auto VoIP
Protocol-based VoIP classifies and prioritizes packets and places them in the higher-priority
queue. By default, the packets are placed in egress queue 6. However, you can override the
egress queue setting. The following example shows how to assign the protocol-based Auto
VoIP to egress queue 4.
queue. By default, the packets are placed in egress queue 6. However, you can override the
egress queue setting. The following example shows how to assign the protocol-based Auto
VoIP to egress queue 4.