Netgear M5300-28G-POE+ (GSM7228PSv1h2) - 12-Port Managed Gigabit Switch Ratgeber Für Administratoren

The purpose of the Spanning Tree Protocol (STP) is to eliminate loops in the switch system. 
There are three STPs: Classic STP (802.1d), Rapid STP (RSTP, 802.1w), and Multiple STP 
(MSTP, 802.1s).

While STP can take 30 to 50 seconds to respond to a topology change, RSTP is typically 
able to respond to changes within a few seconds. RSTP can revert back to 802.1d in order to 
interoperate with legacy bridges on a per-port basis. This drops the benefits it introduces.

In Multiple Spanning Tree Protocol (MSTP), each Spanning Tree instance can contain 
several VLANs. Each Spanning Tree instance is independent of other instances. This 
approach provides multiple forwarding paths for data traffic, enabling load balancing, and 
reducing the number of Spanning Tree instances required to support a large number of 
VLANs.

The example is shown as CLI commands and as a web interface procedure.

(Netgear Switch) (Config)# spanning-tree

(Netgear Switch) (Config)# spanning-tree mode stp

(Netgear switch) (Interface 1/0/3)# spanning-tree port mode

Enable 802.1d on the switch.

a. Select Switching > STP > STP Configuration. 

A screen similar to the following displays.