Zanussi ZFT11105XA Benutzerhandbuch

min.

100 mm

15 mm

15 mm

In the bag with the documentation, there are

two spacers which must be fitted as shown in

the figure.
1. Fit the spacers into the holes. Make sure

that the arrow (A) is positioned as shown in

the picture.

45˚

2. Turn counter-clockwise the spacers through

45° until they lock into place.

Before carrying out any operations,

remove the plug from the power

socket.

To carry out the following

operations, we suggest that this be

made with another person that will

keep a firm hold on the doors of the

appliance during the operations.

1. Tilt back the appliance carefully so that the

compressor cannot touch the floor.

2. Unscrew the left foot.

3. Remove the lower door hinge by

unscrewing the 2 retaining screws.

4. Remove the hinge pin from the bottom of

the door.

5. Slot the hinge pin into the hole in the hinge

plate.

6. Take the door off.

7. Refit the upper hinge pin into the opposite

location.

8. Fit the door in place on the hinge pin.

9. Slot the hinge pin into the hole in the hinge

plate and relocate the hinge assembly to

the opposite location and refit using the

retaining screws.

10. Refit the bottom hinge plate assembly on

the opposite side, taking care that the edge

of the door is parallel with the side of the

cabinet.

11. Remove and install the handle (if foreseen)

on the opposite side.

Reposition, level the appliance, wait

for at least four hours and then

connect it to the power socket.