Samsung Electric Dryer with Steam Benutzerhandbuch

Connecting the inlet hose

The dryer must be connected to the cold water faucet using the new inlet hoses. Do not use old hoses.
1.  Turn the cold water faucet off.
2.  Attach the brass female end of the 

 to the cold water 

faucet.

3.  Attach the straight end of 

 to the Y connector.

4.  Using pliers, tighten the coupling with an additional two-thirds turn.

If the Y connector cannot be attached directly to the cold water 
faucet, the short hose must be used.
(If space permits, please skip steps 5 to 8, and go directly to step 9.)

5.  Attach the 

 to the cold water faucet. 

Screw on the coupling by hand until it is seated on the faucet.

6.  Using the pliers, tighten the coupling with an additional two-thirds 

turn.

7.  Attach the 

 to the brass male end of the small hose. 

Screw on the coupling by hand until it is seated on the connector.

8.  Using the pliers, tighten the coupling with an additional two-thirds 

turn.

9.  Attach the angled end of long hoses to the fill valve at the bottom of 

the dryer rear frame. Screw on the coupling by hand until it is seated 
on the fill valve connector.

10.  Using pliers, tighten the coupling with an additional two-thirds turn.

11.  Attach the 

 to the other side of the 

. 

Screw on the hose coupling until it is tight. Using pliers, tighten the 
coupling with an additional two thirds turn.

12.  Check that the water faucets are on.
13.  Check for leaks around the Y connector, faucets and hoses.

When you tighten the coupling with pliers, do not overtighten. This may damage the coupling.

DV6000HA_DC68-03380A-04_EN.indd   18

2014-11-25     4:46:55