Samsung WF45M5500AP/A5 Benutzerhandbuch
Troubleshooting
English 53
Problem
Action
The washer stops.
• Plug the power cord into a live electrical outlet.
• Check the fuse or reset the circuit breaker.
• Close the door and press START/PAUSE to start the washer.
• Check the fuse or reset the circuit breaker.
• Close the door and press START/PAUSE to start the washer.
For your safety, the washer will not tumble or spin unless the
door is closed.
door is closed.
• Before the washer starts to fill, it will make a series of
clicking noises to check the door lock and does a quick drain.
• There may be a pause or soak period in the cycle. Wait briefly
and the washer may start.
• Make sure the mesh filter of the water supply hose at the
faucets is not clogged. Periodically clean the mesh filter.
• If the washer is not supplied with sufficient power, the
washer temporarily will not drain or spin. As soon as the
washer regains sufficient power, it will operate normally.
washer regains sufficient power, it will operate normally.
Fills with the wrong
temperature water.
temperature water.
• Fully open both taps.
• Make sure the temperature selection is correct.
• Make sure the hoses are connected to the correct taps. Flush
• Make sure the temperature selection is correct.
• Make sure the hoses are connected to the correct taps. Flush
water lines.
• Make sure your water heater is set to supply hot water with a
minimum temperature of 120 °F (49 °C) at the tap. Also, check
the water heater capacity and recovery rate.
the water heater capacity and recovery rate.
• Disconnect the hoses and clean the mesh filters. The mesh
filters may be clogged.
• While the washer fills, the water temperature may change as
the automatic temperature control feature checks incoming
water temperature. This is normal.
water temperature. This is normal.
• While the washer fills, you may notice just hot and/or just
cold water going through the dispenser when cold or warm
temperatures are selected. This is a normal function of
the automatic temperature control feature as the washer
determines the water temperature.
temperatures are selected. This is a normal function of
the automatic temperature control feature as the washer
determines the water temperature.
The load is wet at the
end of a cycle.
end of a cycle.
• Use the High or Extra High spin speed.
• Use high efficiency (HE) detergent to reduce oversudsing.
• The load is too small. Small loads (one or two items) may
• Use high efficiency (HE) detergent to reduce oversudsing.
• The load is too small. Small loads (one or two items) may
become unbalanced and not spin completely.
• Make sure the drain hose is not kinked or clogged.
WF5500M-03773A-01_EN.indd 53
2017-01-10 11:46:23