Samsung RF22K – Réfrigérateur de 22 pi³ à portes françaises (4 portes) et à profondeur de comptoir en acier inoxydable noir avec porte Food ShowCase Benutzerhandbuch

English 

01

 

SETTING

 UP

INSTALLING THE WATER 
DISPENSER LINE

A water dispenser with a filter is one of the helpful 
features on your new refrigerator. To help promote 
better health, the water filter removes unwanted 
particles from your water. However, it does not 
sterilize or destroy microorganisms. You may need 
to purchase a water purifying system to do that.
The water line also connects to the ice maker.
For the ice maker to operate properly, water 
pressure of 20-125 psi (138 ~ 862 kPa) is required.
If the refrigerator is installed in an area with low 
water pressure (below 20 psi), you can install a 
booster pump to compensate for the low pressure.
After you have connected the water line, make 
sure the water storage tank inside the refrigerator is 
properly filled. To do this, press the water dispenser 
lever until the water runs from the water outlet.

Water line installation kits are available at 
extra cost from your dealer.  
We recommend using a water line 
installation kit that contains copper tubing 
and ¼” compression nut.

Connecting to the water supply line

1.  First, shut off the main water supply.

2.  Locate the nearest cold water drinking line and 

install the pipe clamp and shut off valve.

3.  Connect the water line installation kit to the 

shut off valve.

Connecting the water supply line to 
the refrigerator.

There are several items that you need to purchase 
to complete this connection. 
You may find these items sold as a kit at your local 
hardware store.

•  ¼” copper tubing
•  ¼” compression nut 

(1pc)

•  Ferrule (2pc)

•  ¼” plastic tubing  

→

 Molded end(Bulb)

•  ¼” compression nut 

(1pc)

Compression 

Nut (1/4”) 

(Assembled) 

Ferrule 

(Not supplied)

Plastic Tubing
(Assembled)
Compression 
Fitting
(Assembled)

Molded 
end(Bulb)

Compression  
nut (A) (1/4”)  
(Not supplied)

or

Copper tubing
(Not supplied)

Plastic tubing (B)
(Not supplied)

Household water supply line

Refrigerator

1.  Connect the household water line to the 

assembled compression fitting.

 

- If you are using copper tubing, slip the 

compression nut ( 

A ) (not supplied) and 

ferrule (not supplied) on the copper tubing (not 
supplied) as shown.

 

- If you are using plastic tubing ( 

B ) , insert the 

molded end (Bulb) of the plastic tubing ( 

B ) 

into the compression fitting.

Do not use without the molded end (Bulb) 
of the plastic tubing ( 

B ).

2.  Tighten the compression nut ( A ) onto the 

compression fitting. 
Do not over-tighten the compression nut ( 

A ).

RF22KR_DA68-02897B-01_EN.indd   15

2016-03-30     12:47:55