Samsung Indukční varná deska s Flex Zónou NZ84J9770EK Série NZ9900J Benutzerhandbuch
English 45
W
arr
anty and servic
e
Information code
Possible cause
Solution
C0
Check the Auto Cook sensor.
Restart the appliance using the Power
button. If the problem continues,
disconnect power for more than 30
seconds. Then, restart the appliance and
try again. If the problem still continues,
contact a local service center.
button. If the problem continues,
disconnect power for more than 30
seconds. Then, restart the appliance and
try again. If the problem still continues,
contact a local service center.
C1
The temperature is sensed higher
than specified.
than specified.
C2
Check the Auto Cook sensor.
A2
The DC Motor fails to operate
because of problems with the PCB
or wiring, or electrical disturbance
on the motor blade.
because of problems with the PCB
or wiring, or electrical disturbance
on the motor blade.
d0
The sensor is pressed for more
than 8 seconds.
than 8 seconds.
Check if the sensor pad is wet or pressed.
If the problem continues, restart the
appliance using the Power button. If the
problem still continues, contact a local
service center.
If the problem continues, restart the
appliance using the Power button. If the
problem still continues, contact a local
service center.
F0
Communications between main
and sub PCBs fail.
and sub PCBs fail.
Restart the appliance using the Power
button. If the problem continues,
disconnect power for more than 30
seconds. Then, restart the appliance. If
the problem still continues, contact a local
service center.
button. If the problem continues,
disconnect power for more than 30
seconds. Then, restart the appliance. If
the problem still continues, contact a local
service center.
F2
The touch-enabled IC
communicates abnormally.
communicates abnormally.
NZ84J9770EK_EO_DG68-00631A-01_EN.indd 45
2015-02-05 6:12:02