Samsung Notebook Windows Laptops Benutzerhandbuch

127

This function is applied to some models only.

To use the Turn the computer on function, you have to

register your fingerprint first and configure it as follows. 

When finishing the settings, you can turn the computer on

through fingerprint identification or integrated password

authentication instead of entering a password.

 Select

Start > All Programs > OmniPass > 

OmniPass Control Center.

 Select

Change System Settings and then select

either 

Enable or disable pre-boot authentication 

or 

Do Not Use Authentication before Boot.

 Select

Enable System Boot Authentication and 

click the

 Next button.

  Enter the 

Boot Password Setting and click the

Next button.

 Click

Finish to complete the Turn the computer on

function settings.

When turning the computer on, the following screen

appears. Place your finger over the

identification sensor and then remove it.
To use a 

booting password instead of fingerprint 

identification, press the <ESC> key to display the

booting password input screen. Enter the booting

password in the screen. Then you can boot up your

computer.

You can attempt the fingerprint identification up to three

times. If all the three attempts fail, the computer will

automatically shutdown. In this case, turn the computer

on again and retry the fingerprint identification or enter

the booting password.

Canceling the Settings
Unselect the

System Boot Authentication Available 

option in Step 3 above, and then configure it according

to the instructions that appear on the screen.