Samsung SCC-B5343P Benutzerhandbuch

4

  If a hole has been drilled on the bracket installation surface for cable access, press down to remove 

the Cable Stopper and then draw the cable in. If connecting through the side of the camera, use the 

empty space opposite to the side marked 

CAMERA FRONT.

5

  Now attach the Main body to the Mount bracket by rotating it in the LOCK direction after aligning 

the 

Groove mark on the Main body with the wide groove around the CAMERA FRONT inlay.

6

  Adjust the camera direction. For more details on the direction control, see “Adjusting the camera 

direction,” on the same page. When required to adjust the zoom and focus for your camera, see 

“Connecting cables and changing the settings,” on page 10.

7

  Attach the Inner cover to the Main body by pressing it until a “click” sound is heard after aligning 

two screw holes on the 

Wing lockers of the Inner cover with two screw holes on the Main body’s 

left and right sides.

8

  Finally attach the Cover dome to the Main body by pressing it until a “click” sound is heard after 

aligning the bump inside the Cover dome with the 

Groove mark on the Main body.

❚

When the camera is fixed on the ceiling, you can adjust 

the camera viewing angle. You can rotate your camera 

leftward or rightward (Panning), and can change the slope 

of your camera upward or downward (Tilting). 
In case of panning, the rotation limit of your camera is 

set to 355 degree (100 degree clockwise and 255 degree 

counterclockwise). The rotation is stopped by the 

Stopper 

inside of the camera. For panning control, first unfasten 

two screws located on the bottom and rotate in the 

direction you want, and then fasten them to fix the camera.
Tilt can be adjusted between 0° to 90°; however, tilt 

angles of less than 20° may result in a partial blind spot, 

depending on your lens configuration. To fix the location 

after adjusting the tilting angle, use the 

Tilt fixing screws.

To adjust the focus and zoom of your camera, use the 

Zoom lever and Focus lever. When 

you install the camera on the inclined ceiling or wall, you can rotate the camera lens to see 

a correct direction image.

01-B5342_B5343-00648D(03)Eng.ind12   12

2008-08-22   오후 4:49:03