Samsung AP80S0AN Benutzerhandbuch
46
Wiring work
❖
If you are using the grounding on the switching board.
X
f
If the grounding rod is used, user will be responsible for the cost of the grounding work.
X
f
Grounding rod specification
Copper wire
Carbon rod or Copper rod
Grounding wire (green)
Solderless terminal
(For M4 screw)
It could be dangerous if you connect the ground wire to the following places. Therefore, try to avoid connecting
it.
• Television antenna, gas pipe, aluminum chassis, flower vase, water line (You may connect ground wire to the water
• Television antenna, gas pipe, aluminum chassis, flower vase, water line (You may connect ground wire to the water
line if the grounding resistance is less than 3Ω. However, it must be pre-approved to the management authority of
the water line.)
the water line.)
• If above examples cannot be avoided, make sure to get a pre-approval from the experts.
Grounding work procedure
X
f
Make sure that grounding work is done in below procedure.
Procedure
Explanation
Caution
1. Select a place for
grounding.
➀
Appropriate place
• Humid place
• Damp ground is better than sandy ground
• Damp ground is better than sandy ground
➁
Inappropriate place
• Place where with underground structure or
facilities. (Gas pipe, water pipe, Service pipe,
underground cable.)
underground cable.)
• If the grounding wire is paralle to the grounding
pole for the lightning rod, make sure they are at
least 2m apart from each other.
least 2m apart from each other.
• Avoid sandy ground or ground with gravel since
they have high grounding resistance.
• Do not use with the telephone ground wire.
• If you have buried it in a crowded area, firmly fix
• If you have buried it in a crowded area, firmly fix
the ground wire.
2. Bury the grounding
rod.
➀
If you have laying tool for grounding rod:
• Bury the grounding rod to the surface.
• Use the laying tool to bury it at least 20cm deeper
• Use the laying tool to bury it at least 20cm deeper
from the surface.
➁
If you don’t have laying tool:
• Dig a hole as shown in the figure and bury it on
the ground.
• Fill the hole with the soil to bury the entire
grounding rod.
Laying
tool
➀
➁
Ground
rod
Ground
rod
Over 20cm
50cm
30cm
3. Arrange the
grounding wire.
• If you need to extend the ground wire, attach the
putty on the connection part and wind it with a
tape.
tape.
• Fix the grounding wire with staple to prevent it
from getting tangled.
• Use the green vinyl wire with the thickness of the
2mm in diameter or 3.5mm
2
in cross section area
• Make sure that the wire and the wire connection
part is not buried underground.
CAUTION
PAC_아프리카 중동향AP80S0A_IBIM_34514A-02_EN.indd 46
2015-04-23 오후 2:19:00