Sony CDP-CE405

Seite von 32
Additional Information
Additional Information
15
EN
Notes on CDs
On handling CDs
• To keep the disc clean, handle the disc by its edge. Do not
touch the surface.
• Do not stick paper or tape on the disc.
The remote does not function.
/
Remove the obstacles in the path of the remote
and the player.
/
Point the remote at the remote sensor g on the
player.
/
Replace all the batteries in the remote with new
ones if they are weak.
The player functions incorrectly.
/
The microcomputer chips may be operating
incorrectly. Turn the power off, then turn it
back on to reset the player.
Not this way
• Do not expose the disc to direct sunlight or heat sources
such as hot air ducts, nor leave it in a car parked in direct
sunlight as there can be considerable rise in temperature
inside the car.
• Do not use any commercially available stabilizer. If you do,
the disc and the player may be damaged.
• After playing, store the disc in its case.
On cleaning
• Before playing, clean the disc with a cleaning cloth. Wipe
the disc from the centre out.
• Do not use solvents such as benzine, thinner, commercially
available cleaners or anti-static spray intended for vinyl
LPs.
Specifications
Compact disc player
Laser
Semiconductor laser (
λ
 = 780 nm)
Emission duration: continuous
Laser output
Max 44.6 
µ
W*
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
Frequency response
2 Hz to 20 kHz ± 0.5 dB
Signal-to-noise ratio
More than 102 dB
Dynamic range
More than 98 dB
Harmonic distortion
Less than 0.0045%
Channel separation
More than 100 dB
Output
Jack
type
Phono
jacks
Maximum
output
level
2 V
(at 50 kilohms)
Load
impedance
Over 10 kilohms
LINE OUT
General
Power requirements
220 V – 230 V AC, 50/60 Hz
Power consumption
14 W
Dimensions (approx.)
430 
×
 120 
×
 385 mm
(w/h/d)
(17 
×
 4 3/4 
×
 15 1/4 in.) incl. projecting
parts
Mass (approx.)
5.6 kg (12 lbs 6 oz)
Supplied accessories
Audio cord (2 phono plugs – 2 phono plugs)  (1)
Remote commander (remote) (1)
Sony SUM-3 (NS) batteries (2)
Design and specifications are subject to change without notice.
Troubleshooting
If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There’s no sound.
/
Check that the player is connected securely.
/
Make sure you operate the amplifier correctly.
/
Adjust the playback level using the LINE OUT
LEVEL +/– on the remote.
The CD does not play.
/
There’s no CD inside the player (“no DISC”
appears). Insert a CD.
/
Place the CD with the label side up on the disc
tray correctly.
/
Clean the CD (see above).
/
Moisture has condensed inside the player.
Remove the disc and leave the player turned on
for about an hour (see page 2).
Additional Information