Sony CDX-M730 Installationsanleitung
Precautions
•Choose the installation location carefully so
that the unit will not interfere with normal
driving operations.
driving operations.
•Avoid installing the unit in areas subject to
dust, dirt, excessive vibration, or high
temperatures, such as in direct sunlight or near
heater ducts.
temperatures, such as in direct sunlight or near
heater ducts.
•Use only the supplied mounting hardware for
a safe and secure installation.
Mounting angle adjustment
Adjust the mounting angle to less than 60°.
Extended portion of the front
panel (4)
panel (4)
How to detach and attach the
front panel (5) (CDX-M730
only)
front panel (5) (CDX-M730
only)
Before installing the unit, detach the front
panel.
panel.
5-A To detach
1 Press (OPEN) on the unit for 2 seconds.
The front panel automatically tilts at an angle
of 30°
of 30°
2 Detach the front panel as illustrated.
After the front panel is completely detached,
the sub display closes automatically.
the sub display closes automatically.
5-B To attach
Place the front panel on the front side of the unit
as illustrated, then lightly push the front panel
into position until it clicks.
as illustrated, then lightly push the front panel
into position until it clicks.
Mounting example (6)
Installation in the dashboard
When installing this unit, be sure to close the
front panel of the unit. (6-
front panel of the unit. (6-
*
)
If the front panel is opened while installing and
given too much force, it may cause a
malfunction.
given too much force, it may cause a
malfunction.
Mounting the unit in a Japanese
car (7)
car (7)
You may not be able to install this unit in some
makes of Japanese cars. In such a case, consult
your Sony dealer.
makes of Japanese cars. In such a case, consult
your Sony dealer.
Note
To prevent malfunction, install only with the
supplied screws 4.
To prevent malfunction, install only with the
supplied screws 4.
Warning when installing in a car
without ACC (accessory)
position on the ignition key
switch
without ACC (accessory)
position on the ignition key
switch
Be sure to press (OFF) on the unit for two
seconds to turn off the clock display after
turning off the engine.
seconds to turn off the clock display after
turning off the engine.
When you press (OFF) only momentarily, the
clock display does not turn off and this causes
battery wear.
clock display does not turn off and this causes
battery wear.
RESET button (8)
When the installation and connections are
completed, be sure to press the RESET button
with a ballpoint pen, etc.
completed, be sure to press the RESET button
with a ballpoint pen, etc.
使用前注意事項
•請仔細選擇安裝位置，以使本機不妨礙正常的
駕駛操作。
•避免將本機安裝在多塵、髒亂、極易受震動的
地方，或者高溫之處，如陽光直射處或暖氣機
前。
前。
•為了安全和安裝牢固，安裝時請使用附送的安
裝部件。
安裝角度之調整
請在 60 度以內調整安裝角度。
前面板的伸出部分（4）
如何拆卸和裝配前面板（5）
(僅限於CDX-M730)
(僅限於CDX-M730)
安裝本機之前，請先拆卸前面板。
5-A 拆卸
1. 按住本機上的 (OPEN) 鍵2秒鐘。
前面板自動傾斜 30 度角。
2. 如圖所示拆下前面板。
前面板完全拆下後，副顯示幕自動關閉。
5-B 裝配
如圖所示將前面板放在本機的前面，然後輕輕推
入前面板，直至發出喀嗒聲。
入前面板，直至發出喀嗒聲。
安裝示例（6）
安裝在儀錶板裡
安裝時必須關閉前面板。（
6-
*
）
安裝時若前面板開著，以及施以太大的力，都會
造成故障。
造成故障。
將本機安裝於日本產汽車上時
（7）
（7）
有的日本產汽車不能安裝本機，在這種情形下，
請您向當地的 Sony 經銷商諮詢。
請您向當地的 Sony 經銷商諮詢。
註
為防止發生故障，安裝時只能使用附送的螺絲 4。
為防止發生故障，安裝時只能使用附送的螺絲 4。
安裝在點火鑰匙開關上沒有 ACC
（輔助）位置的汽車上時的警告
（輔助）位置的汽車上時的警告
在關掉汽車引擎之後，一定請按下機器上的
(OFF) 兩秒以關掉時鐘顯示。
(OFF) 兩秒以關掉時鐘顯示。
如果只短暫地按一下 (OFF)，將不會關掉時鐘顯
示而浪費電池。
示而浪費電池。
RESET 按鈕（8）
當安裝和連接完成後，必須用原子筆等按壓
RESET 按鈕。
RESET 按鈕。