Sony CDU926S Benutzerhandbuch

1

49

50

Red Edge

±

±

1

2

49
50

Sony CDU926S Drive

Power
Supply
Cable

Red Edge

SCSI Card
(Not included)

Speakers
(Not included)

Sound Card
(Not included)

Audio Cable

SCSI 

Cable

(Not included)

Connect the free end of the flat cable to the existing SCSI host adapter
card and install the host adapter in the computer by inserting it securely in
a system expansion slot. Refer to the operating instructions of the host
adapter for complete instructions on its installation and the assignment of
its switches.

●

The red edge of the flat cable must be closest to pin number 1 of the 
interface card connector.

●

The following illustration is a sample system configuration of the 
Sony CDU926S CD-R drive installation with a SCSI card.

Installing the Drive Unit into the Computer      15

Locate an available power supply cable inside your computer and 
connect it to the power supply connector on the rear of the CD-R drive 
as shown.

Caution: Improper connection may damage the drive and void the warranty.

■

When normally installed, the drive unit is not in contact with the host
computer directly and should be grounded. Connect the frame ground tab
to one of the host computer’s ground cables.

The frame ground cable recommended has a AMP 1-480435-0 housing and
170203-2 or 60711-1 contacts.

14      Installing the Drive Unit into the Computer

Frame ground tab

Frame ground 
cable

5V - 5%

GND

PARITY

2

ID SELECT

PREVENT/ALLOW

TEST MODE

INTERFACE CONNECTOR

DC INPUT

12V - 10%

+

+

Power Supply
Connector

Power Supply Cable